Verus Engineering Vortex Generator Kit - Ford Mustang Shelby GT350/GT350R A0307A
1. The Shelby GT350R features a lot of aerodynamic components from the factory.
2. Verus Engineering spotted detached flow on the rear glass during analysis.
3. Detached flow in this area increased drag and reduces flow due to the location of the factory wing.
4. This will causes the factory rear wing to not work as hard as it can.
5. Adding Verus Engineering vortex generators, your factory GT350R will reduce drag and increase downforce over the factory setup.
6. With Verus Engineering rear wing installed, you will still get the benefits of the reduced drag but the downforce increase will no longer be there.
7. The vortex generators are part of the Ventus 1 kit which increases downforce slightly and reduces drag from the factory vehicle.
8. These units are produced from 2x2 twill carbon fiber and install within 30 minutes with double-sided tape.
9. WHAT IS INCLUDED
• (6) Carbon Fiber Vortex Generator
• (6) 3M Double Sided Tape
• (1) Install Template
10. FEATURES
• Reduction in Drag by 0.003, or 3 Points
• OEM Fit and Function
SPECIFICATIONS
• 2x2 Twill, Pre-Preg Carbon
• Simple Install
• 3M Double-Sided Tape
No comments:
Post a Comment