Scotidi Quick Angle Kit for Ford Mustang 05-10 009-006-0462
100% BOLT ON, NO DRILLING REQUIRED!
1. A seriously capable kit for a seriously good price, the Scotidi Quick Angle kit takes the new approach to drifting suspension parts.
2. It may seem that a full custom spindle and control arm setup is the only way to get a high performing kit, but the quick angle kits have proven otherwise.
3. The bolt on spindle adapters provide the same benefits that a standalone spindle would at a fraction of the price and allows you to keep more easily replaceable parts on your car.
4. This kit offers:
a verifiable 62° of steering angle
3 position ackerman adjustment
roll center correction
PTFE lined rod end joints for more steering feel and to eliminate the squirm of rubber bushings
Stock spindle trail correction
Version 2.0 now has 1 piece arms! While the 2 piece arms added on car adjustment, they proved to be finicky and less robust. Not to mention the 1 piece arms are stronger, simpler, and less expensive!
5. This kit includes:
Spindle Adapters
1.625" Roll center correction
3 position ackerman adjustment
Optimized steering arm length to maximize angle
BIllet Aluminum construction
Steering stop plates that bolt on to the factory spindle
6. Control Arms
Double shear rear mount
Integrated steering stop
Minimum 2" over factory arm length
Extended Tie Rods
Extended length for drift applications
PTFE lined rod ends
(The selection of model year is based upon the ball joint size. If you are unsure of which model year or ball joint/spindle combination you have, you can measure the diameter of the ball joint shaft or the mating hole. The 05-10 will have a ~.705” diameter ball joint and the 11-14 will have a .750”.)
*Requires coil over kit
* NOT DOT APPROVED, TRACK USE ONLY!
No comments:
Post a Comment