Porsche, Honda, Audi, Volkswagen, Ford, Dodge,Toyota, Subaru, Mitsubishi, Mercedes

Tuesday, October 22, 2024

HPS Cold Air Intake Kit 19-21 Genesis G70 3.3L V6 Twin Turbo, Includes Heat Shield, Red 827-703R

 

HPS Cold Air Intake Kit 19-21 Genesis G70 3.3L V6 Twin Turbo, Includes Heat Shield, Red 827-703R

HPS Cold Air Intake Kit 19-21 Genesis G70 3.3L V6 Twin Turbo, Includes Heat Shield, Red 827-703R

HPS Cold Air Intake Kit 19-21 Genesis G70 3.3L V6 Twin Turbo, Includes Heat Shield, Red 827-703R


1. The All-New HPS Performance 827 Series Air Intake Kit (Red, Part # 827-703R) was designed for 2019-2021 Genesis G70 3.3L V6 Twin Turbo 

2. Gives a free-flowing 2-3/4 inch mandrel-bent aluminum tube induction system that produced dyno proven performance gains +12.1 Whp horsepower, +12.7 Ft/lbs torque.

3. Improved throttle response while maintaining safe air fuel ratio. 

4. The heavy duty powder coated steel heat shield integrates with the factory fresh air scoop to direct cold air to the air filters for the best cooling effect. 

5. The included installation manual has clear pictures and instructions to guide the installer throughout the whole process. 

6. The kit does NOT require tuning and does not trigger CEL light. 

7. No modification is required during the installation. 

8. HPS light weight mandrel-bent aluminum alloy tubes replace the stock restrictive air box and optimize the air flow with long lasting durability. 

9. HPS Performance 827 Series air intake kit features race proven reinforced silicone hoses and industrial grade 100% stainless steel T-bolt clamps which ensures reliability, even during the most extreme driving conditions. 

10. All HPS Performance Air Filters are made in the United States.

***HPS Performance Air Filter Key Features:

Woven cotton filter element- Traps dirt up to 5 microns. Superior airflow without sacrificing filtration.- Washable and reusable, saving you money down the line.

Specially formulated light-weight synthetic oil- Creates an ionic bond with the filter's stainless steel mesh.- Attracts and traps dirt onto the mesh, creating a clear path for airflow.- Will not affect or damage sensors.

Stainless steel mesh reinforcement- Higher resistance to dents over aluminum mesh.

Low pressure injection molding- Effectively minimizes seepage of rubber onto filter element.- Increases airflow by up to 25% compared to high pressure molding.


No comments:

Post a Comment